tag:blogger.com,1999:blog-6576338411571923751.post1470115059730890951..comments2023-05-10T01:58:43.233-07:00Comments on Froggin4Bass: PowerPole Micro Install (2015 Hobie Outback)Hanover_Yakkerhttp://www.blogger.com/profile/09560110180149151925noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-6576338411571923751.post-16949288249536858152018-01-10T06:57:37.548-08:002018-01-10T06:57:37.548-08:00Sorry for the delayed response, but I've been ...Sorry for the delayed response, but I've been on vacation from work and dealing with the home life and family. The very first part of this installation removes that port side cleat, and since it's not an open hole pass through, there is no risk of leaking. The bungee itself is still there, it's just laid over to the right side now, so that it can still be utilized. One tip I should've done and can still do is to install a small YakAttack or RAM ball mount on the forward port side of the mount plate that the bungee can hook to across the rudder and holding it in place. When installed and the rudder is stowed, the ball will be approximately at the 11 o'clock position. Hope that helps!! Hanover_Yakkerhttps://www.blogger.com/profile/09560110180149151925noreply@blogger.comtag:blogger.com,1999:blog-6576338411571923751.post-85825104385935682902017-12-01T06:38:40.418-08:002017-12-01T06:38:40.418-08:00Really nice write up! Just received my mount, came...Really nice write up! Just received my mount, came with no instructions. Given that it involves drilling want to make sure I'm following best practices. What did you do with the rudder tie down bungie? What did you do with the rudder tie down cleat you removed? Wondering if the rudder tie down is still usable after mount is installed. Anonymoushttps://www.blogger.com/profile/02658374028389154349noreply@blogger.com